Audi A4, S4

Since 2000 of release

Repair and car operation

Removal and cowl installation/adjustment

1 — the Cowl
2 — the Loop
3 — Two bolts, 21Нм

4 — Two nuts, 21Нм
5 — Gazonapolnennyj an emphasis

Removal

PERFORMANCE ORDER

Open a cowl
Disconnect a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.

Disconnect a hose and disunite a jet socket стеклоомывателя.
For possibility of the subsequent installation mark cowl position.
Ask the assistant to take a cowl (1). A small screw-driver raise a lock spring (arrow) a little. Disconnect газонаполненный an emphasis (5) from the top spherical support.
Turn on on two nuts (4) it is left and on the right and remove a cowl together with the assistant.

Installation

PERFORMANCE ORDER

Establish a cowl together with the assistant on a loop (2). Adjust cowl position on earlier put label.
Establish and fix газонаполненный an emphasis on a spherical support.
Close a cowl and expose it, observing backlashes, see more low.
Tighten nuts (4) moment 21Нм.
Installation is carried out in sequence, return to removal.
Attach a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.

Check/adjustment

PERFORMANCE ORDER

Check up backlashes on a cowl contour. Backlashes should be uniform on all perimetre прилегания to body elements. And — 5.5 ± 0.5 mm In — 5.5 ± 0.5 mm With — 3.5 ± 0.5 mm D — 4.0 ± 0.5 mm Е — 1.5 ± 0.5 mm F — 1.5 ± 0.5 mm G — 2.5 ± 0.5 mm
It is a little ослабьте a nut (4), address to an illustration in the section beginning.
Close a cowl and expose it on wings. Adjust cowl position. Cautiously open the exposed cowl not to shift it. Tighten nuts of fastening of loops the moment 21Нм.
Loosen the 4 bolts of fastening so that it was possible to displace the lock (1).
Adjust a cowl by lock displacement on height. Tighten bolts of fastening of the lock the moment 14Нм.
Adjust cowl position on height in relation to wings. For this purpose screw a forward emphasis (1) and (2) at a cowl. By a reversing of an emphasis adjust cowl height in relation to wings. Put a few plasticine between a cowl and wings and check up, whether has an emphasis at the closed cowl contact to the forward panel. An emphasis at the closed cowl should adjoin to the forward panel.

Recycling газонаполненного an emphasis

PERFORMANCE ORDER

If газонаполненный the emphasis is replaced, it is necessary to let out gas from an old emphasis.

For this purpose clamp an emphasis in a vice in the area designated on an accompanying illustration (х = 50 mm).

Emphasis clamp necessarily only and the specified area, otherwise there is a danger of accident! Then надпилите the cylinder on distance of one third of total length from a base mark from outside a rod. For protection against oil emission cover area реза with a rag. Besides, in time пиления use goggles.

home