Audi A4, S4

Since 2000 of release

Repair and car operation


Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
   Security measures at work
   + Suspension bracket of forward wheels
   + Suspension bracket of back wheels
   + Corners of installation of wheels of the car
   - Steering and safety pillows
      The general data and security measures
      Removal and installation of the block of a pillow of safety
      Removal and steering wheel installation
      Removal and installation of a tip of steering draught
      Removal and installation of a protective cover of the steering mechanism
+ Body
+ Onboard electric equipment



Removal and installation of a protective cover of the steering mechanism

Removal

 PERFORMANCE ORDER

  1. Remove a tip of steering draught, turn away a counternut, address to Section Removal and installation of a tip of steering draught.
  2. Take out a cover of steering draught.
  1. Open a collar and шланговый a clip (arrows) of a protective cover.
  1. Remove a protective cover.

If the cover long time has been damaged, hit in the dirt mechanism can be a consequence of it. The dirt in a combination to greasing operates as наждачная paste, destroying the steering mechanism. In this case, and also in the presence of rust traces on gear рейке, it is necessary gear рейку to hand over in repair (work HUNDRED).

Installation

 PERFORMANCE ORDER

  1. At installation of a protective cover watch that small diameter of a cover was included into a groove of steering draught and a cover it was not braided.
  2. Apply new a collar and шланговый a clip.
  3. Establish into place a cover of steering draught.
  4. Establish a tip of steering draught, address to Section Removal and installation of a tip of steering draught.


home