Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
Security measures at work
+ Suspension bracket of forward wheels
+ Suspension bracket of back wheels
+ Corners of installation of wheels of the car
- Steering and safety pillows
The general data and security measures
Removal and installation of the block of a pillow of safety
Removal and steering wheel installation
Removal and installation of a tip of steering draught
Removal and installation of a protective cover of the steering mechanism
+ Body
+ Onboard electric equipment
|
Removal and installation of a tip of steering draught Removal
|
- Mark on the tyre a direction of its rotation. Turn away bolts of fastening of a wheel. Lift and establish on supports a forward part of the car and remove a wheel.
|
- Turn out a bolt (1).
|
|
- Turn away a nut (5) and turn out a bolt (2).
|
|
Do not expand шлиц in the case of the bearing of a wheel with a chisel or any other similar tool. |
|
Do not apply a chisel or any similar tool to removal of steering draught by забивания it between the pendular lever (1) and a sealing washer (2) tips of steering draught. Steering draught can act in film only by выпрессовки the end of a pin of a tip from the steering lever or blows of a wooden or rubber hammer. |
|
- Remove steering draught downwards.
|
|
- Turn away a counternut (3) and turn out a tip from steering draught.
|
- Wipe a tip of steering draught and клеммное an aperture on the case of the bearing of a wheel.
|
|
Installation
|
- Screw a tip on steering draught against the stop.
- Tighten a counternut (3) moment 40Нм. HUNDRED AUDI apply for this purpose tool V.A.G 1332/12. At an inhaling keep steering draught from проворачивания for шестигранник (4).
- Expose steering draught so that the tip pin was in installation position.
|
- Insert steering draught against the stop into the pendular lever.
|
|
|
Steering draught insert into the pendular lever (1) only by hand, thus do not press strongly on a sealing washer (2) tips. |
|
- Insert a bolt (2) and screw a new nut (5), tighten a nut the moment 50Нм.
|
|
- Establish a bolt (1) and tighten its moment 7Нм.
|
- Establish and fix a wheel, observing a direction of its rotation. Lower the car and only after that tighten bolts cross-wise the moment 120Нм.
- Spend measurements of a running gear of the car (work HUNDRED).
|
|
|
home
|