Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
Security measures at work
+ Suspension bracket of forward wheels
- Suspension bracket of back wheels
The general data
Removal and installation of a screw spring
Removal and shock-absorber installation
+ Corners of installation of wheels of the car
+ Steering and safety pillows
+ Body
+ Onboard electric equipment
|
Removal and installation of a screw spring Removal
|
|
For removal of a screw spring the special adaptation is necessary. HUNDRED AUDI apply to this purpose the adaptation for compression V.A.G. 1752/1, adapter V.A.G. 1752/9 and the holder of spring V.A.G. 1752/16. |
|
|
- Mark with an arrow on the tyre a direction of rotation of a wheel. Loosen the bolts of fastening of a wheel. Lift and establish on supports a back part of the car and remove a wheel.
|
|
- Establish on a spring the adaptation for compression of a spring with an adapter and the holder of a spring. If necessary, at first insert the holder of a spring into coils and then connect it to the adaptation. Thus watch to damaging трапециидального the lever.
|
|
|
It is necessary to compress four coils. If it is not possible, compress three coils and then turn a spring so that it was possible to compress four coils. Watch correct position of a spring in the holder. Danger of accident! |
|
- Compress the adaptation against the stop and remove a spring.
|
|
Installation
|
|
- At installation of a new spring watch that its conic end looked downwards. Colour labels (In on an accompanying illustration) should show the marksman downwards.
|
|
- Insert a pin of a support of a spring (1) into an aperture трапециидального the lever (2).
- Turn the spring end so that it lay on an emphasis of a support of a spring (arrow).
- Insert the top lining of a spring (on an illustration it is not shown) into the top end of a spring.
- Cautiously ослабьте a spring. Thus level position of the top lining of a spring.
- Observing a direction of rotation of a wheel, fix a back wheel. Lower the car on wheels and only after that tighten bolts of fastening of a wheel cross-wise the moment 120Нм.
|
|
|
home
|