Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
Security measures at work
+ Suspension bracket of forward wheels
- Suspension bracket of back wheels
The general data
Removal and installation of a screw spring
Removal and shock-absorber installation
+ Corners of installation of wheels of the car
+ Steering and safety pillows
+ Body
+ Onboard electric equipment
|
Removal and shock-absorber installation
The shock-absorber
Removal
|
|
The special tool is necessary for shock-absorber removal. HUNDRED AUDI apply to this purpose the adaptation for compression V.A.G.1752/1, adapter V.A.G. 1752/9 and the holder of spring V.A.G. 1752/16. |
|
|
- Mark with an arrow on the tyre a direction of rotation of a wheel. Loosen the bolts of fastening of a wheel. Lift and establish on supports a back part of the car and remove a wheel.
- Remove a spring, address to Section Removal and installation of a screw spring.
|
- Turn away a nut (1) and take out a bolt (on an accompanying illustration the guard is not shown).
|
|
- Turn out a bolt (2).
|
|
|
The wheel casing does not act in film. |
|
- Take out the shock-absorber.
|
- At отворачивании and an inhaling of nuts of fastening of a support of the shock-absorber keep from проворачивания a rod. HUNDRED AUDI apply for this purpose the special tool 3017А.
|
|
|
Installation
|
|
- Establish a support on the shock-absorber and fix its new self-stopped nut the moment 25Нм.
|
- Tighten bolts (2) moment 36Нм. Watch position of the bottom fastening.
- At first tighten a nut of the bottom fastening of the shock-absorber (1) moment 30Нм.
|
|
- Establish into place a spring, address to corresponding Section.
- Observing a direction of rotation of a wheel, fix a back wheel, lower the car on wheels and only after that tighten bolts of fastening of a wheel the moment 120Нм.
|
|
The inhaling of a nut of the bottom fastening of the shock-absorber is necessary for making as follows:
|
|
- Lower the car on wheels.
- Loosen the the bottom fastening of the shock-absorber.
- Some times press through a car suspension bracket.
- Tighten a new nut (1) moment 150Нм and then tighten on a corner 90 °.
|
|
|
home
|