Audi A4, S4

Since 2000 of release

Repair and car operation


Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
- Manual box of a gear change
   Specifications
   Removal and check point installation
   Check of level of oil in a manual check point
   Adjustment of a drive of a gear change
   Check of adjustment of the lever of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Check of level of oil in a manual check point

 PERFORMANCE ORDER

  1. Establish the car on an equal platform.
  2. Lift and establish the car on a platform.
  1. Turn out a stopper for filling with oil depending on execution by a face key on 10 mm, for example, HAZET 985-10 or a face key under a polyhedron, for example, AUDI-3357 or HAZET 2567-16. The stopper is located at the left on a check point under the gauge of a measuring instrument of speed and can be closed теплоозащитным the power shaft screen.
  1. Check up level of oil by means of a wire bent at an angle. Oil level should be on 7 mm below the bottom edge of an aperture for заливания oils.

Filling also to level of the bottom edge of an aperture is supposed. Apply only synthetic oil specified in Specifications.

  1. Tighten a stopper the moment 25Нм.

Stopper different for a check point from aluminium and magnesian alloys.



home