Audi A4, S4

Since 2000 of release

Repair and car operation

Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
- Manual box of a gear change
   Removal and check point installation
   Check of level of oil in a manual check point
   Adjustment of a drive of a gear change
   Check of adjustment of the lever of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Adjustment of a drive of a gear change


  1. Uncover the lever of switching and the lever handle, address to Section Removal and installation of a cover of the lever of switching of transfers/selectors.
  1. Pull an overlay (1) at first in an arrow direction () and then take out in an arrow direction ().

At cars with the control panel of the conditioner located over an ashtray, it is necessary to extend the panel preliminary a little.

  1. Turn out fastening bolts () and take out an ashtray (2) of the central console.
  1. Take out upwards демпфирующую a washer (1) and демпфер noise (2).
  1. Turn out bolts of fastening of a cover (an arrow on an accompanying illustration).
  1. Measure distance () between two carving fingers in a switching drive.

It is necessary to measure centre to centre fingers.

  1. The distance should be and = 85 mm. If the received value differs from specified, adjust distance () as follows: Loosen the the screw (arrow) of fastening of a pushing bar. The pushing bar should move easily in both parties behind in a switching drive on ползуне.
  1. Adjust the size () by displacement of a pushing bar behind. Tighten a bolt of fastening of a pushing bar the moment 25Нм.
  1. Loosen the a bolt (an arrow on an accompanying illustration) in a switching drive. Connection a pushing bar/drive of switching should have an easy course.
  1. Establish the switching lever: the Lever should be centered below in a spherical support. The distance from a spherical support to the switching lever below from different directions should be identical.
  1. Establish the lever vertically in a direction of movement and keep it in this position.
  1. Tighten a bolt of fastening of a bar of switching by the moment 25Нм.
  1. Tighten bolts of fastening of a cover of protection against noise by the moment 10Нм. Watch installation position: the Arrow on a cover specifies in a direction "forward".
  1. The button of inclusion with the fixing mechanism: Establish the button together with a cover of the lever of switching on the lever and turn a connecting element against the stop.
  2. The button of inclusion with a tightening collar: Establish the inclusion button сновым a collar on the lever of switching and squeeze a collar flat-nose pliers.
  3. If necessary, establish the block of management of the conditioner and an ashtray.