Audi A4, S4

Since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
- The engine
   Specifications
   Removal and installation of the top cover of the engine / the bottom protection of an impellent compartment/stretcher
   Compression check in engine cylinders, revealing of leaks
   Check of the engine by means of the vacuum gauge
   + 4-cylinder petrol engines
   + 6 and 8-cylinder petrol engines
   + 4-cylinder diesel engines
   - 6-cylinder diesel engines
      The general data
      Removal and installation of a gear belt of drive ГРМ
      Removal and installation of a head of the block of cylinders
      Removal and installation of a belt of a drive of auxiliary units
   + System of greasing of the engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of a gear belt of drive ГРМ

Gear belt of a drive of camshafts. The diesel engine of 2.5 l

1 — the Wheel of a gear belt of a cranked shaft. Installation is possible only in one position. Oil hit on an adjoining surface a wheel / a cranked shaft is not supposed
2 — the Device of a tension of a gear belt
3 — the Bolt, 10Нм
4 — the Screw, 42Нм
5 — the Tension lever. Enclose a washer 7
6 — the Screw, 42Нм
7 — the Washer of the tension lever
8 — the Tension roller. Enclose a washer 20
9 — the Bolt with a fillet, 75Нм
10 — a camshaft Wheel. For a camshaft of inlet valves
11 — the Gear belt
12 — the Bolt, 10Нм
13 — the Pump of a cooling liquid
14 — the Bolt, 10Нм

15 — the Back right cover of a gear belt
16 — the Back central cover of a gear belt
17 — the Back left cover of a gear belt
18 — the Sealing lining. Necessarily replace
19 — the Wheel of a camshaft of inlet valves
20 — the Washer of a tension roller
21 — the Bolt with a fillet, 75Нм
22 — the Directing roller
23 — the Bottom cover of a gear belt
24 — the Bolt, 10Нм
25 — the Screw, 45Нм
26 — the Remote plug
27 — the Bolt, 200Нм + 180 °

Gear belt of drive ТНВД

1 — the Holder of the fan with вязкостной муфтой
2 — the Nut, 36Нм
3 — the Screw, 22Нм
4 — Dempfer крутильных fluctuations of wheel ТНВД
5 — Gear belt ТНВД

6 — ТНВД
7 — Wheel ТНВД with a persistent fillet on one or on two parties. At installation establish in the centre of grooves. After installation check up the beginning of injection and adjust (work HUNDRED)
8 — the Washer
9 — the Screw, 22Нм
10 — the Tension roller. For a gear belt of drive ТНВД


home