Audi A4, S4

Since 2000 of release

Repair and car operation


Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
- Systems of cooling, heating and the air conditioner
   + Cooling system
   - Systems of ventilation, heating and air conditioning
      The general information and security measures
      Removal and installation of the air snuffled
      Removal and installation of the electric motor of a drive ventilating заслонки
      Removal and installation of the block of management by a heater/conditioner
      Removal and installation of the electric motor of a drive of the fan of a heater and the conditioner
      Removal and installation of the gauge of temperature of external air
      Removal and installation of an additional heating element
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of the electric motor of a drive of the fan of a heater and the conditioner

The block of management of the fan of fresh air is established on the electric motor and can act in film and be replaced only together with the electric motor.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.

  1. Remove a ware box, address to Section Removal and installation of a ware box.
  1. Disunite a socket ().
  1. Release a cable connector ().
  2. Remove facing on a rack And, address to Section Removal and installation of facing of a rack And.
  3. Cautiously cast away a rug around an arrangement of feet.
  1. Take aside шумозащитный a floor-mat and turn out the screw ().
  1. Take aside шумозащитный a floor-mat and take out from a heater the fan (D) with the built in block of management.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, return to removal.
  2. At installation pay attention to correct position of the fan in a heater.
  3. Fix a cable a connector.


home