Audi A4, S4

Since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Specifications
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Рассоединение sockets
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Check of stoplights
   Removal and installation of a sound signal
   Removal and installation of gauges of a parking
   Replacement of the battery of a remote control of the ignition key
   The relay and safety locks
   Replacement of lamps накаливания devices of external illumination
   Removal and installation of headlights
   Removal and installation of the lateral repeater of turns
   Removal and installation of an additional stoplight
   Removal and installation of a back lantern
   Removal and installation of a lantern of illumination of licence plate
   Removal and installation of plafonds of internal illumination
   Removal and control panel installation
   Removal and installation подрулевого the switch
   Removal and installation of switches of a forward door
   Removal and installation of the switch of light
   Removal and switch installation стеклоподъёмника in a back door
   Removal and installation of the switch of a cover of a luggage carrier
   Removal and installation of the switch of a lay brake
   Removal and installation of the switch of illumination of a ware box
   Removal and installation of switches of the central console
   Removal and radio receiver installation / the navigating device/CD-changer
   Removal and installation of loudspeakers
   Removal and installation of aerials
   Removal and installation of the tank of a liquid of the stekloomyvatelja/electric motor of the pump
   Removal and installation of the electric motor of a cleaner of a windscreen
   Removal and electric motor installation on back glass (Versatile person)
   The uniform lock - the general information
   Removal and installation запорного an element of a cover of a fuel tank
   The digital tyre of given CAN
   + Basic schemes of an electric equipment





Replacement of lamps накаливания devices of external illumination

Devices of system of illumination concern: headlights, antifog headlights, back lanterns, stoplights, backing lanterns, indexes of turns, foggy lanterns, lanterns of illumination of licence plate and devices of internal illumination.

The lamp exit накаливания is out of operation displayed on the universal display. (Information system of the driver (FIS)).

There is a danger травмирования!

Be careful at replacement of the xenon lamps of a high voltage in headlights! Just in case switch off a headlight and disconnect the storage battery. After replacement quickly switch on and off a headlight to remove residual stress. From safety reasons carry footwear with rubber soles.

Lamps накаливания and holders of lamps can appear very hot. Therefore before replacement of lamps накаливания wait coolings of the lighting device.

Store lamps in a place inaccessible to children.

Do not apply the fallen lamps or lamps with scratches, they can burst.

накаливания it is not necessary to take a glass flask of a lamp hands. For this purpose is better to use napkins or cotton gloves. Fingerprints evaporate and besieged on a reflector, obscuring it. Casually formed stains on a flask are necessary for removing by means of pure, not containing fibres, a towel moistened in spirit.

накаливания it is necessary to replace lamps only with lamps of the same execution.

 PERFORMANCE ORDER

  1. Switch off ignition and the headlight switch.
  2. Disconnect a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.

Passing light

 PERFORMANCE ORDER

  1. The right headlight: Disconnect the top cover of the engine, and also an air line between the forward panel and the air filter.
  2. The left headlight: Remove a headlight, address to corresponding Section.
  3. Uncover a headlight underside. For this purpose take away wire скобу from a cover.
  1. Galogenovaja lamp: Disunite a socket (2), take away wire скобу and remove a lamp (3).
  1. The xenon lamp: Turn the tip (1) counter-clockwise and remove. Release wire скобы (arrows on an accompanying illustration) and take out a lamp from the case.
  1. Insert into the case a new lamp, fix it скобой and join a socket.
  2. Establish a cover from an underside of a headlight and fix скобой.
  3. The further installation is carried out in sequence, return to removal.

Headlight/parking light

 PERFORMANCE ORDER

  1. The right headlight: Disconnect the top cover of the engine, and also an air line (subsection "Passing light").
  2. The left headlight: Disunite sockets over a headlight, unblock the holder and remove it upward.
  3. Uncover a headlight a headlight underside. For this purpose take away wire скобу from a cover.
  1. Galogenovaja headlight: Turn the electric motor of adjustment of range of light, remove from a headlight and put aside.

At the right headlight turn counter-clockwise (an arrow on an accompanying illustration), at the left headlight clockwise.

  1. Lay light / the xenon headlight: Turn the electric motor of adjustment of range of light, remove from a headlight and put aside.
  1. Headlight: Disunite a socket (3), release скобу (2) and take out a lamp (1) of the case. Insert a new lamp, fix it скобой and join a socket.
  1. Parking light: Release lock pads and take out a cartridge (the marksman on an accompanying illustration) from the case. Take out a lamp from a cartridge, replace it on new and insert a cartridge into the case.
  1. Establish from an underside of a headlight the electric motor of adjustment of range of light, establish into place a cover of a headlight and fix it скобой.
  2. The further installation is carried out in sequence, return to removal.

The turn index

 PERFORMANCE ORDER

  1. Remove a headlight, address to Section Removal and installation of headlights.
  1. Turn a cartridge (the marksman on an accompanying illustration) counter-clockwise and take out it from the case.
  1. Press a lamp into a cartridge, turn and take out.
  2. Replace a lamp new and insert a cartridge into the case.
  3. Establish into place a headlight, address to Section Removal and installation of headlights.


home