Audi A4, S4

Since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   The general data and security measures at carrying out кузовных works
   Cleaning and leaving
   Repair of insignificant damages кузовных panels
   Repair of considerable damages of a body
   + The external equipment
   - The salon equipment
      Remarks on work with the salon and security measure equipment
      Removal and installation of spring clips
      Removal and installation of the central console
      Removal and installation of the holder of drinks
      Removal and installation of facing of the lever of a lay brake
      Removal and installation of a cover of the lever of switching of transfers/selectors
      Removal and ashtray installation
      Removal and installation of the central armrest
      Removal and installation of an internal mirror
      Removal and cover installation on a control panel
      Removal and pocket installation from outside the driver
      Removal and installation of a ware box
      Removal and installation противосолнечного a peak
      Removal and installation of facing of a rack And
      Removal and installation of the top facing of a rack In
      Removal and installation of the bottom facing of a rack In
      Removal and installation of a forward overlay of a threshold
      Removal and installation of facings (Sedan)
      Removal and installation of facings (Versatile person)
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of a forward seat belt
      Removal and installation of a back seat belt
+ Onboard electric equipment






Removal and installation of a forward seat belt

Removal

 PERFORMANCE ORDER

At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures.

Remember position of installation of a seat belt since there can be various variants.

  1. To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive accumulator room cables
  2. Disconnect facing of a rack And around a rack In, address to corresponding section.
  3. Disconnect facing of a rack D/facing over a back door (Versatile person) around a rack In, address to corresponding section.
  4. Remove rack facing In above and below, address to corresponding Section.
  1. Remove a seat belt (1) at a forward seat, address to Section Removal and installation of a forward seat.

The arrow And on an accompanying illustration shows in a direction of movement of the car. (2) – a belt tip, (5) – directing a belt.

  1. Turn out the screw (4) and take out the device for taking - up of a belt (3).
  2. Extend a screw-driver a yellow safety lath and disunite a yellow-dark blue socket (9).
  3. Turn out the screw (7) and disconnect a belt (1) from a regulator of height (6). (8) - a bolt of fastening of a regulator of height, 23Нм.

Installation

 PERFORMANCE ORDER

Do not press a lock key (10) regulators of height of a belt in an installation time.

  1. Installation is carried out in sequence, return to removal.
  2. If at certain execution of a belt the lock uvula in not a working condition of a belt is directed towards a rack In, it is necessary to turn a belt tape at installation on 180 ° (an arrow on an illustration above).
  3. Tighten bolts (4) and (7) moment 55Нм.
  4. Check up work of a regulator of height of a belt, address to Section Removal and installation of the top facing of a rack of Century

During joining of the storage battery in salon there should not be people.

  1. Remove isolating tape from a negative pole of the storage battery, attach at first positive (+), and then a negative cable (-) to a battery accumulator room.

Observe instructions Replacement of the storage battery Has undressed.



home