Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
The general data and security measures at carrying out кузовных works
Cleaning and leaving
Repair of insignificant damages кузовных panels
Repair of considerable damages of a body
+ The external equipment
- The salon equipment
Remarks on work with the salon and security measure equipment
Removal and installation of spring clips
Removal and installation of the central console
Removal and installation of the holder of drinks
Removal and installation of facing of the lever of a lay brake
Removal and installation of a cover of the lever of switching of transfers/selectors
Removal and ashtray installation
Removal and installation of the central armrest
Removal and installation of an internal mirror
Removal and cover installation on a control panel
Removal and pocket installation from outside the driver
Removal and installation of a ware box
Removal and installation противосолнечного a peak
Removal and installation of facing of a rack And
Removal and installation of the top facing of a rack In
Removal and installation of the bottom facing of a rack In
Removal and installation of a forward overlay of a threshold
Removal and installation of facings (Sedan)
Removal and installation of facings (Versatile person)
Removal and installation of a forward seat
Removal and installation of a back seat
Removal and installation of a forward seat belt
Removal and installation of a back seat belt
+ Onboard electric equipment
|
Removal and installation of a back seat belt Removal
|
- Switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Stick the negative plug of the storage battery изоляционной with a tape. Instructions are resulted in Section Replacement of the storage battery.
-
Sedan: Remove facing of rack D, address to corresponding Section.
-
Sedan: remove a shelf, address to corresponding Section.
-
Sedan: Remove демпфирующий an element under a shelf.
- Remove lateral facing of a luggage carrier / a cargo compartment, address to corresponding Section.
|
- Turn out the screw (2) at the device for taking - up of a belt (1), and also a bolt (5) at a belt tip.
|
|
- Disunite a socket (7) and disconnect a cable of the device for a tension of a belt from the holder (4). (8) – a cover of protection against noise.
- Extend the device for taking - up of a belt (1) of lock apertures (3) and take out together with a seat belt.
|
|
Installation
|
- Installation is carried out in sequence, return to removal. Thus watch a correct lining of a cable of a belt. Tighten bolts (2) and (5) moment 55Нм.
|
During joining of the storage battery in salon there should not be people. |
- Remove isolating tape from a negative pole of the storage battery, attach at first positive (+), and then a negative cable (-) to a battery accumulator room.
|
|
Back directing a belt
Removal
|
- Remove a lateral pillow of a back seat, address to Section Removal and installation of a back seat.
- Remove a seat belt.
|
- Take out a detail from polyfoam (4).
|
|
- Turn out 2 bolts (2) and take out directing a belt (1) of lock apertures.
|
|
Installation
|
- Installation is carried out in sequence, return to removal. Thus both washers (3) should lie over lock apertures. Directing for a belt it should be fixed distinctly.
|
|
|
home
|