Check and starting position adjustment сдвижной roof panels Electric motor installation сдвижной panels in a starting position
|
|
- Close сдвижную the panel.
- Remove a forward ceiling plafond, address to Section Removal and installation of plafonds of internal illumination.
- Turn away screws of fastening and remove the electric motor сдвижной panels.
- Electric wires of the electric motor do not disconnect.
- Include ignition.
- Establish the rotary switch position «the Roof it is closed». Thus the electric motor works automatically and stops in zero position.
- In this position establish the electric motor at the closed roof and fix it.
- Establish a forward plafond.
|
|
Starting position check кулисной the directing
|
|
|
|
The starting position can be checked up by means of a pocket mirror and a pocket lantern at established сдвижной panels. |
|
- Remove lateral overlays at the left and on the right, address to corresponding Section.
|
- Open and again close сдвижную the panel.
|
- Shift the ceiling panel completely back.
|
- Put on сдвижную the panel a pocket mirror and check up a starting position. At correct installation a rectangular groove in the promotion mechanism кулисной directing (1) should coincide with a groove (an arrow on an accompanying illustration). Otherwise make adjustment.
|
|
|
Installation of a directing side scene in a starting position
|
|
- Remove сдвижную the panel.
- Remove the panel electric motor.
- Remove lateral overlays, address to corresponding Section.
- Displace кулисные directing (1) from both parties from back position forward.
- Establish a rectangular groove in the promotion mechanism кулисной directing (1) so that it coincided with a groove (marksman) on the directing tyre (2) panels of a ceiling. Thus the starting position of a directing side scene is established.
- Establish the electric motor сдвижной panels in a starting position.
- Establish lateral overlays.
|
|
|