Removal and installation of an external mirror Mirror replacement
Removal
|
- Disconnect a negative cable (-) the storage battery.
|
|
- Open a door and take out a triangular overlay from three holders of clips. Thus an overlay at first disconnect below.
|
- Turn out the screw (7) and remove a mirror with the block of adjustment (2) from a door (5).
|
|
- Disunite a socket (6). (3) – the bottom cover.
|
|
Installation
|
- Installation is carried out in sequence, return to removal. Thus watch correct position of consolidation (8) at the basis of a mirror (9). Tighten the screw (7) moment 12Нм.
- Tighten consolidation at a window frame over a triangular overlay.
- Attach a negative cable (-) the storage battery.
|
|
Replacement of glass of a mirror
Removal
|
- Disconnect a negative cable (-) the storage battery.
|
|
- Paste over the case of a mirror with a tape above and below to protect it from damage.
|
|
- Cautiously hook a plastic wedge mirror glass at first below, and then above.
|
- Take out glass from the case and disunite a socket of heating of a mirror.
|
|
Installation
Operation of lifting and car installation on supports is connected with danger! Therefore before operation carrying out familiarise with Razdelom Poddomkrachivanie and towage.
|
- Establish glass of a mirror (4) on a basic plate (2) and join a socket of heating of a mirror.
|
|
- Insert glass into directing pins and displace a finger (3) in a frictional spring (marksman).
|
- Fix glass, thus press only in the glass centre. (1) – the mirror case.
|
- Attach a negative cable (-) the storage battery.
|
|
|
Replacement of the case of a mirror
Removal
|
-
Remove mirror glass, address to corresponding Section.
|
- Turn out screws (4), disconnect the bottom cover (3) of holders and remove downwards.
|
|
- Disconnect the case of an external mirror (1) of holders (arrow) and remove upward.
|
|
Installation
|
- Establish the case of an external mirror from above on the block of adjustment (2).
- Fix the case above and below on the block of adjustment (2). Thus holders of the block of adjustment should enter into lock hooks of the case.
- Insert from below a cover (3), fix and fix.
- Establish to the place of mirror glass.
|
|
|