Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
The general data and security measures at carrying out кузовных works
Cleaning and leaving
Repair of insignificant damages кузовных panels
Repair of considerable damages of a body
- The external equipment
Installation of the forward panel in position for maintenance service
Removal and installation of a cover of a water modular compartment
Removal and installation of a forward bumper
Removal and installation локера a back wing
Removal and installation локера a forward wing
Removal and installation of a forward wing
Removal and installation of a back bumper
Removal and cowl installation/adjustment
Removal and installation of a cable of a drive of a cowl
Removal and installation of a clamp of the lock
Removal and installation of facing of a forward door
Removal and installation of facing of a back door
Removal and door installation
Door adjustment
Removal and installation of a frame of a window of a forward door
Removal and installation стеклоподъёмника
Removal and installation of the electric motor of a drive стеклоподъёмника
Removal and installation of the lock of a door
Removal and installation of the handle of a door
Removal and installation of the cylinder of the lock of a door
Removal and installation of facing of a cover of a luggage carrier
Removal, installation and adjustment of a cover of a luggage carrier
Removal and installation of the lock of a luggage carrier
Removal and installation of facing of a door of a back (Versatile person)
Removal and installation of a door of a back (Versatile person)
Removal and installation of the lock of a door of a back (Versatile person)
Removal and installation of an external mirror
Removal and installation молдингов
Removal, installation and check сдвижной roof panels
Removal and overlay installation сдвижной roof panels
Check and starting position adjustment сдвижной roof panels
Removal and sealant installation сдвижной panels
Replacement of elastic bands of brushes of a screen wiper
Removal and jet installation стеклоомывателя a windscreen
Removal and installation of a jet of a washer of back glass
Removal and installation of the lever of a cleaner of a windscreen
Removal and installation of the lever of a cleaner of back glass
Removal and installation of jets фароомывателя
Adjustment of levers of a screen wiper
+ The salon equipment
+ Onboard electric equipment
|
Removal, installation and adjustment of a cover of a luggage carrier Sedan
Removal
|
- Disconnect a negative cable (-) the storage battery.
|
|
- Remove facing of a cover of a luggage carrier, address to Section Removal and installation of facing of a cover of a luggage carrier.
- Disunite sockets and take out from a luggage carrier cover.
|
|
For simplification of installation it is necessary to fix a cord which after вытягивания wires remains in a cover on the ends of a wire. |
|
- For repeated installation: Mark with a felt-tip pen position of balance weights of loops (3) on a luggage carrier cover.
|
|
- Remove газонаполненный an emphasis, address to Section Removal and installation of a door of a back (Versatile person).
- Ask the assistant to take a cover of a luggage carrier and turn on on 2 nuts of fastening (1) and (2) at the left and on the right in a luggage carrier cover.
- Uncover a luggage carrier by means of the assistant.
|
|
Installation
|
- Establish a cover of a luggage carrier by means of the assistant into place. An old cover expose on earlier put labels.
- Screw on two nuts at the left and on the right.
- Establish газонаполненный an emphasis, address to Section Removal and installation of a door of a back (Versatile person).
- Release клиновой the lock, close a cover of a luggage carrier and adjust its position so that the backlash on a contour прилегания was uniform, address to corresponding Section.
- Tighten a nut the moment 21Нм.
- The further installation is carried out in sequence, return to removal.
- Attach a negative cable (-) the storage battery.
|
|
Check and adjustment
|
- Check up backlashes of a cover of a luggage carrier. The backlash on a contour прилегания should be uniform.
|
|
- Remove facing of overlapping of a back, address to Section Removal and installation of facings (Sedan).
|
- Loosen the nuts (1) so that it was possible to displace клиновой the lock (2).
|
|
- Close a cover of a luggage carrier and adjust a backlash on a contour прилегания.
- Open a cover of a luggage carrier and tighten fastening nuts клинового the lock the moment 8Нм.
- Establish into place facing of overlapping of a back, address to Section Removal and installation of facings (Sedan).
|
- Remove rubber covers (2) on an emphasis at the left and on the right and screw an emphasis (1) completely in a luggage carrier cover.
|
|
- Screw an emphasis so that the closed cover (3) was заподлицо with adjoining elements of a body, and an emphasis slightly adjoined to a cargo edge (4).
- Put on an emphasis rubber covers.
|
|
|
home
|