Audi A4, S4

Since 2000 of release

Repair and car operation

Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
- Current leaving and service
   The indicator of term of approach of maintenance service
   The routine maintenance schedule
   The general information on adjustment
   Check of levels of liquids, the control of leaks
   Check of a condition of tyres and pressure in them. A designation of tyres and disks of wheels. Rotation and replacement of wheels
   Replacement of impellent oil and the oil filter
   Checks of brake system. Adjustment of a lay brake
   Check of fuel system
   Check of a condition and replacement of hoses of an impellent compartment, localisation of leaks
   Check of a condition of ridge belts of a streaming drive of auxiliary units
   Check of functioning of system of cooling and frost resistance of a cooling liquid
   Check of a condition of system of release of the fulfilled gases
   Check of level of oil of automatic transmission
   The visual control of a box of a gear change and the main transfer on leaks, check of level and oil addition
   Check of a condition a suspension bracket and steering component
   Check of a condition of protective covers of power shafts
   Check of level of a liquid of system of hydrostrengthening of a wheel
   Check of a central air of air
   Greasing of terminators of doors, cylinders of locks, cowl hook, сдвижной panels of the hatch of a roof
   The visual control of a seat belt and the block of a pillow of safety
   Check of working capacity of headlights and horn
   Condition check, adjustment and replacement of brushes of screen wipers
   Check of a condition of the battery, care it and gymnastics
   Replacement of the battery of emergency supply of system Telematik
   Replacement of an element of the filter of air of salon / the coal filter of clearing of air
   Replacement of a brake liquid
   Check and replacement of spark plugs. Check of a condition of high-voltage wires
   Replacement of an element of the air filter of the engine
   Replacement of the fuel filter
   Check of a condition and tension of a gear belt
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Check of working capacity of headlights and horn


  1. Include ignition and check up working capacity of all external lighting devices.
  2. By means of the assistant or having adjusted the car a backing to any wall, check up working capacity of stoplights. By pressing a brake pedal stoplights should be lighted only. Include all possible lighting devices located in back block headlights (backing signals, dimensional fires, etc.) then again press a brake pedal. If at inclusion of stoplights you find out failure in work any of other included signals, unreliable contact to "weight" or bad contact in a block headlight can be the reason for it.
  3. Now check up working capacity of optics. Include near, then a headlight.
  4. At detection of the fused lamps replace them, following the recommendations resulted in the Head the Onboard electric equipment.
  5. Check up working capacity of all внутрисалонных lighting devices, including illumination of a ware box and a luggage space. Include ignition and be convinced that all control lamps have lighted up. In the Head Controls and receptions of safe operation it is in detail described, what lamps should light up at ignition inclusion. Start the engine. Control lamps should go out. Making a trip to a night-time, check up working capacity of all lamps of illumination (both a control panel, and the instrument panel). At failure detection address to corresponding section of the Head the Onboard electric equipment. Sometimes, lamps can fail because of occurrence on them or on rust cartridges. Having replaced a lamp, you will not get rid of a problem. In this connection, at replacement of any lamp, attentively examine a cartridge from within. At detection of adjournment of green or white colour remove their emery paper.
  6. Include a passing light.
  7. Establish a regulator of range of light in various positions and check up, whether beams of light of both headlights are equally adjusted.
  8. In summary check up working capacity of a horn.