Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
- Current leaving and service
Specifications
The indicator of term of approach of maintenance service
The routine maintenance schedule
The general information on adjustment
Check of levels of liquids, the control of leaks
Check of a condition of tyres and pressure in them. A designation of tyres and disks of wheels. Rotation and replacement of wheels
Replacement of impellent oil and the oil filter
Checks of brake system. Adjustment of a lay brake
Check of fuel system
Check of a condition and replacement of hoses of an impellent compartment, localisation of leaks
Check of a condition of ridge belts of a streaming drive of auxiliary units
Check of functioning of system of cooling and frost resistance of a cooling liquid
Check of a condition of system of release of the fulfilled gases
Check of level of oil of automatic transmission
The visual control of a box of a gear change and the main transfer on leaks, check of level and oil addition
Check of a condition a suspension bracket and steering component
Check of a condition of protective covers of power shafts
Check of level of a liquid of system of hydrostrengthening of a wheel
Check of a central air of air
Greasing of terminators of doors, cylinders of locks, cowl hook, сдвижной panels of the hatch of a roof
The visual control of a seat belt and the block of a pillow of safety
Check of working capacity of headlights and horn
Condition check, adjustment and replacement of brushes of screen wipers
Check of a condition of the battery, care it and gymnastics
Replacement of the battery of emergency supply of system Telematik
Replacement of an element of the filter of air of salon / the coal filter of clearing of air
Replacement of a brake liquid
Check and replacement of spark plugs. Check of a condition of high-voltage wires
Replacement of an element of the air filter of the engine
Replacement of the fuel filter
Check of a condition and tension of a gear belt
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of a condition of protective covers of power shafts
|
- Protective covers of power shafts are very important elements since they protect hinges of equal angular speeds (SHRUS) from hit on them a dirt, water and other extraneous subjects causing damages. External pollution of protective covers by oil and greasings can lead to premature failure of a material of covers, therefore it is recommended to wash periodically covers with water with soap.
- Lift and establish the car on supports.
- Remove the bottom cover of an impellent compartment, address to Section Removal and installation of the top cover of the engine / the bottom protection of an impellent compartment/stretcher.
|
- Shine with a lamp protective covers (1) and check up them on presence of cracks. Pay attention to presence of traces of greasing on covers and near to them. In case of detection of signs of cracks or leak of greasing the cover should be replaced.
|
|
- If a cover will involve inside or has damage, it is necessary to replace it immediately.
- Check up reliability of fastening of collars (2).
- At the same time check up the general condition of hinges of equal angular speeds, holding a shaft and simultaneously trying to turn a wheel. Repeat attempt, holding the internal hinge of equal angular speeds and turning a shaft. Any appreciable люфт specifies in deterioration of the hinge, deterioration in grooves of a shaft or отворачивание a lock nut of a shaft.
- Establish into place the bottom cover of an impellent compartment.
- Lower the car on wheels.
|
|
|
home
|